Basic Operation
Once the window coverings have been
joined to a GROUP or multiple GROUPS,
the remote is ready to operate the window
covering(s). Multiple window coverings
can be operated at the same time.
NOTE: Some PowerView
®
window
treatments offer variable operation from
the basic operation listed here. For full
instructions on how to operate your
PowerView window treatment, please
consult the IOC that came with your
window treatment.
BASIC OPERATION
1. To wake up the remote, simply
pick it up or press
STOP. The last
GROUP(S) selected will be highlighted
and active.
2. Press ALL or GROUP 1– 6 button(s)
to select specific window covering(s)
to operate. Selected GROUP
button(s) will light to show they
are selected.
a. Multiple GROUP buttons may
be selected at the same time.
b. To deselect a GROUP, press the
GROUP button again. The backlit
GROUP button will go out.
3. Press
OPEN to open the
selected window covering(s).
4. Press
CLOSE to close the
selected window covering(s).
5. For window covering(s) with vanes,
louvers or a middle rail*, press the
RIGHT ARROW to close the window
covering and open the vanes, rotate
the vanes to the right, tilt the louvers
up or fully raise the middle rail.
6. For window covering(s) with vanes,
louvers or a middle rail, press the
LEFT ARROW to close the vanes,
rotate the vanes to the left, tilt the
louvers down or fully lower the
middle rail.
a. NOTE: Single-function window
coverings will not operate by
pressing the ARROW buttons.
7. Press
STOP to stop window
covering/vane/louver movement
anywhere along its travel.
8. While a window covering is in
motion, press the opposite of its
motion (
OPEN or CLOSE) to
reverse direction.
9. Press
♥
FAVORITE to send selected
window covering(s) to your preset
FAVORITE position.
* Applies to Top-Down/Bottom-Up and Duolite
®
window coverings only. The bottom rail on
Top-Down/Bottom-Up window coverings operates
using the OPEN and CLOSE commands.
OPEN
CLOSE
LEFT ARROW
Function varies
by product type
RIGHT ARROW
Function varies
by product type
STOP
Stops window
covering motion
GROUP NUMBERS
Each number represents
a different group
FAVORITE
• Click once to send shade(s)
to your favorite position*
• Double click to send
shade(s) to your second
preset favorite position**
* The default favorite positions vary based on
the shade type.
* Both favorite positions can be updated in the
PowerView App under the shade’s settings.
NOTE: Additional functions vary by product
type.To view your window covering’s
specific functions, please consult your
Installation, Operation and Care manual.
You can find this here https://help.
hunterdouglas.com/s/installation-
instructions
4