HunterDouglas PowerView - Manual

PowerView® Vertical Blind
The PowerView® VVB motor is suited to be used with Vertical blind hardware from HunterDouglas.
1. Delivery condition
As standard, no remote control or hub is connected to the motor. No limits are set. Motor is default set to a
Left stack
Vertical blind
motor type. If the motor condition is unknown, perform the following steps.
1.1. Check motor type
The motor can be programmed as a
• Left stack Vertical blind (default)
• Right stack Vertical blind
• Split stack Vertical blind
By reading out the LED sequence after power up, the motor type can be seen.
Vertical Venetian blind
IMPORTANT
The motor type (default set to
Left stack Vertical blind
), might be changed to a
Right stack Vertical blind
or
Split stack Vertical blind
type, depending on your wishes.
Use the
PowerView® Programmer
software tool to change.

Note
The PowerView® Vertical blind motor can only be installed to the back of the headrail and
not
on top!

MANUAL
Page 1 of 24 version: 1.1