HunterDouglas PowerView User Guide

Battery Replacement
5
REPLACING BATTERIES
IN THE REMOTE
Replacing the batteries in the remote
module will not cause the loss of any
window covering programming, including
GROUPS and FAVORITE. The remote uses
two CR 2032 batteries.
1. For the Pebble
®
Remote, slide your
thumb in the indentation, gently
lift and remove the remote module
from the Pebble. For the Surface
Remote, remove the Surface from
its mounting plate by twisting the
Surface counter-clockwise. Push the
remote module out from the back of
the Surface.
5. Insert new batteries, making sure
each is snug.
6. Align and replace the back cover
onto the backside of the remote
module.
7. Using the flathead screwdriver,
rotate the screw clockwise two
times or until the screw is snug.
8. Align the ribs on the remote module
with the grooves on the Pebble
®
or
the Surface.
9. Gently push the remote module
into the Pebble or the Surface until
it is snug.
2. Using a flat-head screwdriver, rotate
the safety screw counter-clockwise
two times.
3. Remove the back cover from
the remote.
4. Using a finger or small screwdriver,
gently lift and remove the old batteries.

HunterDouglas PowerView Specifications

General

Power Source	Battery
Type	Remote Control
Technology	Radio Frequency (RF)
Battery Type	CR2032
Compatibility	Hunter Douglas motorized shades and blinds
Connectivity	RF
Buttons	Multiple
Dimensions	Varies by model
Weight	Varies by model