HunterDouglas PowerView - Inside;End Mount - Standard Shades

INSTALLATION
7
Inside/End Mount — Standard Shades
■
If you ordered bracket covers. Mark
1
⁄ 8 " in from each window jamb for the outside
edge of each bracket.
■
Shades without bracket covers. Mark
1
⁄ 16 " in from each window jamb for the outside
edge of each bracket.
➤
The minimum depth required for mounting is 2
3
⁄ 4 ". For fully recessed mounting, the
depth is 3
1
⁄ 4 ".
IMPORTANT: The front edges of the installation brackets must be level and aligned to
eachother.
■
Place the outside edge of the brackets on the previously made marks, then mark each of
the screw holes.
■
Drill the screw holes using a
1
⁄ 8 " drill bit.
WARNING: Product is heavy. Mount into wood/metal studs or into concrete
with concrete anchors. Drywall anchors are not recommended.
■
Use a level to check that the mounting surface is level. Shim the brackets if necessary.
■
Attach the installation brackets using the screws provided.
➤
End Mount Shims (Optional). To ensure light gap is even on both sides, you may
need to shim the bracket. Do not tighten the screws fully. Orient the shim as shown.
Slide the shim in between the bracket and window casement. Tighten the screws
fully.
Proceed to “STEP 2 — Install the Shade” on page 15.
Inside Mount
End Mount
Shim
(Optional)