HunterDouglas Provenance - Provenance Shades Care & Maintenance; Removing the Drapery

CARE
14
Removing the Drapery (If Necessary)
■ Release the Universal Cord Tensioner.
➤ Remove the screw securing the Universal Cord Tensioner to its installation bracket.
■ Remove the drapery from the carriers.
➤ At each grommet, separate the carrier hinge from the post. Roll the drapery from
the leading edge to the stationary end, so that the stationary end is on the outside
of the roll.
Outside Mount: Standard Valance Removal
■ Push up on the release tab on the mounting clips, to release the valance from the headrail.
■ Unhook the mounting clip from the front groove in the headrail. Repeat for each
mountingclip.
Headrail Removal
■ Firmly support the headrail.
■ Push up on the release tab to release the headrail. Repeat for each mounting clip.
■ Unhook the mounting clip from the front groove in the headrail.
Valance
Push Up
on Tab
Mounting Clip
Release Tab
Valance
Remove
Headrail
Push Up
on Tab
Remove
Headrail
Mounting Clip
Release Tab
Push Up
on Tab
Mounting Clip
Release Tab
Headrail
Valance
Inside Mount
Outside Mount