HunterDouglas Provenance - Provenance Shades Installation; Tools and Fasteners Needed

INSTALLATION
2
Thank you for purchasing the Hunter Douglas Provenance
®
Woven Woods vertical drapery.
With proper installation, operation, and care, your new drapery will provide years of beauty
and performance.
■ Please thoroughly review this instruction booklet and the enclosed packing list before
beginning the installation.
■ Carefully remove the rolled up fabric and set aside. Do not unroll the fabric until
installation. Carefully remove the headrail and optional valance from the packaging.
Keep all packaging until the unit operates to your satisfaction.
Tools Needed
■ Flat blade and Phillips screwdrivers
■ Level (laser level is recommended)
■ Measuring tape and pencil
■ Power drill,
3
⁄ 32 " drill bit, and ¼" hex driver
In addition, you will need fasteners designed to work with your specific mounting surface(s).
Brackets and Fasteners Needed
■ Outside Mount Installation Brackets. The number of installation
brackets required varies with headrail width, as shown in the
tablebelow.
■ #8 x 1½" Hex Head Screws (Provided). The number of screws
required for inside mounting varies with headrail width, as shown
in the tablebelow. Two screws are provided per outside mount
installation bracket.
■ Drywall Anchors (Not Provided). Use drywall anchors when
mounting into drywall.
Width
Outside Mount
Brackets
Inside Mount
Screws
36" – 56" 3 6
56
1
⁄ 8 " – 80" 4 8
80
1
⁄ 8 " – 104" 5 10
104
1
⁄ 8 " – 128" 6 12
128
1
⁄ 8 " – 152" 7 14
152
1
⁄ 8 " – 176" 8 16
176
1
⁄ 8 " – 192" 9 18
#8 x 1½"
Hex Head Screw
(Provided)