12 SERVICE WORK ON THE CHASSIS 60
12.40 Checking the frame x
101861-01
– Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame. x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by HUS-
ABERG.
12.41 Checking the swingarm x
401341-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm. x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by HUSABERG.
12.42 Checking the routing of the throttle cable
Preparatory work
– Remove the seat. ( p. 49)
–
Remove the fuel tank. x ( p. 54)
B01259-10
Main work
– Check the routing of the throttle cable.
Both throttle cables must be routed to the throttle valve body side by side behind
the handlebars and above the fuel tank bearing.
» If the throttle cable is not routed as specified:
– Correct the routing of the throttle cable.
Finishing work
–
Install the fuel tank. x ( p. 55)
– Mount the seat. ( p. 49)
To Next Page
Loading...
Need help?
General
