FILE MAN:fl.yER a-SECTION 3. 6
VER.V09F
c) Set up the HUNTER comms parameters as before.
d) On the IBM, select baud rate.
i.e. type
'3' for 4800 baud.
e) When prompted with:
(R)eceive or (T)ransmit _
type 'r' for receive, The following message will then
appear on the bottom line.
'any key to abort'
f) Enter Basic on the HUNTER with the Basic file loaded into
the workspace, On the HUNTER type:
LLIST
This will list the Basic program to the
IBM for storage in
the selected file.
g) Transmission is over when the HUNTF.R displays:
READY
h) Hit any key on the IBM to close its file,
An ASCII file with Basic Text may be transferred directly into
the Basic workspace using the LLOAD command in Basic. This is
done as follows:
a) Plug the cable into the HUNTER and ir:to the asynchronous
port.
b) Switch on the HUNTER and enter the file manager.
c) Set up the HUNTER comms parameters.
d) On the HUNTER enter Basic and type:
LLOAD
e) On the IBM-PC, select the baud rate:
i.e. type
'3' for 4800 baud
f) You are now prompted with:
(R)receive or (Tlransrnit
Type
't' for transn:i t.
PAGE 3 - 56
To Next Page
Loading...