FILE MANAGER
SECTION 3.6
3.6.5.5
3.6.5.6
VER.V09F
IBM-PC Ccxmunications Program
The files supplied on disk are:
Ca-1MS1 .BAS
BASIC.COM
HUNTCOM.BAT
To run the program, follow these steps:
a) Turn on the IBM-PC
b) Insert a 'DOS' disk into the A drive
c) Insert the supplied disk into the B drive
d) Copy the files onto the A disk:
copy B:*.* A:
e) Remove the B disk and store in a safe place
f) Type:
huntcom
g) The IBM comms program is now running and asking for your
selection of baud rate.
It displays:
Asynchronous Communications Program
select baud rate ('s' for system):
( 1) 300
(2) 1200
(3) 4800
Loading files from the IBM-PC
Make sure the file you want to send is on one of the disks in
the IBM-PC and also that the three communications files are on
the disk in the A slot,
a) Plug the cable into the HUNTER and into the asynchronous
port.
b) Switch on the HUNTER and enter the file manager.
c) Set up the HUNTER comms parameters.
d) On the HUNTER, type:
INP no.blocks filename
PAGE 3 - 53
To Next Page
Loading...