Husky Hunter - Page 105

FILE MANAGER
SECTION 3,6
From the filemanager:
(i) INP
(ii) SEND
and the following HUNTER BASIC commands/statements:
(i) L.LOAD
(ii) LLIST
(iii) LINPUT
(iv) LPRINT
(v) LINCHR
(vi) LOPCHR
See also the section on Communications, Section 6, with
particular attention to comms parameter setup,
b) The Illf-PC
Special software is required for full communication capabilities
on the IBM-PC, This software, together with the interface
cable, is available from Husky Computers Limited on an IBM disk,
3,6,5,4 HUNTER Coom.lnications Set-up
VER.V09F
To communicate in both directions at 4800 baud, the
communication parameters should be set as follows:
TRANSMIT RECEIVE
Rate
- 4800 Rate
- 4800
Prtcl
- None
Prtcl
- None
Prty
- 8-bit.
Prty
- 8-bit
CTS - y
RTS
- hold
DTR
- n
DSR
- n
FCHO
- n
DCD
- n
LF
- n
&>rig - Off
Null
- 0
TIO
- no
TIO
- no
The above setup allows full bi-directional communications with
hard ware handshaking, Both ASCII text files and 8-bit object
code files can be up and down loaded.
PAGE 3 - 52