APPENDIX
9.9.3
9. 9.3.1
VER.V09F
SECTION 9.9
LEMO CONNECTOR
The four pin LEMO plug is installed by aligning the red mark on
the plug sleeve with the corresponding red mark on HUNTER's LEMO
socket, the square pin on the plug body must also align with the
key-way on the socket. The LEMO plug is then pushed firmly into
HUNTER's socket until the outer sleeve of the plug is flush with
the casing of HUNTER'S LEMO socket.
Removal of LEMO Plug
To remove the LEMO plug from HUNTER it is necessary to pull b3ck
the spring loaded outer sleeve before pulling the plug out of
HUNTER'S socket.
PAGE 9 - 43
To Next Page
Loading...