APPENDIX
9. 14
9. 14. 1
9, 14.2
VER.V09F
SECTION 9.14
CONFIGURING TYPICAL CP/M PROGRAMS
This appendix describes the installation procedure for a number
of common commercial CP/M programs. The purpose of the
installation is to configure the program to the screen handling
control codes within HUNTER.
The control codes used by the HUNTER screen are:
a) Clear Screen
b) Home Cursor
c) Cursor Addressing
d) Cursor Right
e) Cursor Left
f) Cursor up
g) Cursor down
01H
02H
OFH, <x co-ord>,<y co-ord>
OCH
08H
OBH
OAH
The installation procedure is generally carried out on a
standard CP/M desk-top machine prior to down-loading
information, see Section 3,6
MBASIC
Standard disk-based Microsoft Basic can be down-loaded into
HUNTER with no installation or modification.
The only file to transfer is MBASIC,CCT1, MBASIC may now be run.
WORDSTAR VERSION 2
The standard disk from MicroPro has the following files:
INSTALL, COM
wsu.crn
WSMSGS,OVR
WSOVLY1.0VR
The INSTALL program is used to configure the main Wordstar
program WSU,COM or an existing Wordstar file (WS.COM).
The two overlay files, WSMSGS,OVR and WSOVLY1.0VR, do not need
any alteration,
When using the INSTALL program, refer to the Wordstar manual for
further information - INSTALL is faily self explanatory. The
main features of the procedure are explained below:
1) Type INSTALL to load and run INSTALL on your desk-top unit,
2) Select the appropriate Wordstar file, e.g. WSU.COM.
PAGE 9 - 50
To Next Page
Loading...