Husky Hunter - Command: COMS

FILE MANAGER
COMS
3,4.3,3
COMMAND
EXPLANATION
JEXAMPLES
REMARKS
VER.V09F
SECTION 3.4
COMS
Initialise the communications parameters,
Two screens are used to select the
communications parameters as follows:
Transmission Parameters
Prtcl-none
Pty-none
Rate-1800
CTS-n DTR-n
LF-n Echo-n T/0-no NULL-0
press ENTER if acceptable
Receiving Parameters
Rate-1200
RTS-off DSR-n
Prtcl-none Pty-none
DCD-n T/0-No Serig-off
press ENTER if acceptable
See section 6.4, COMMUNICATIONS PORT SOFTWARE,
for information on selecting communication
parameters.
NOTE: Communication parameters are not reset
when HU~TF:R is powered off.
In CP/M, the serial communications interface is
assigned the following logical devices:
Transmit -
l.'\T:, PUN:
Receive - RDR:
PAGE 3 - 14