FILE MANAGER
SECTION 3,6
VER.V09F
After typing ENTER, HUNTER will respond with
* Waiting
To abort use the ESC key.
If PIP is to be used to
transfer the file to HUNTER using the LST: printer
port, then type on the host computer
PIP LST:=MAIN.COM[O]
The [ 0] suffix is very important because this tells PIP
to list using the full 8 bits. HUNTER will respond to the
beginning of transmission with the message ·
* Loading
If too many blocks have been specified in the INP command
then after transmission has completed the 'waiting'
message will again be displayed. In this case use the ESC
key to complete the transference of the file.
The file MAIN.COM will now reside in a HUNTER file.
Step 4 Load OVRERLAY ,OVR
The sequence of commands for loading this file is as
follows:
HUNTER
Host
>INP 40 OVERLAY ,OVR
PIP LST:=OVERLAY.OVR[O]
Step 5 Load PRODUCTS.TXT
This file is.loaded with these commands:
HUNTER
Host
>INP 56 PRODUCTS.TXT
PIP LST::PRODUCTS.OVR[O]
Step 6 Run the program
The three files MAIN.COM, MAIN.OVR and PRODUCTS.TXT
should all now be in HUNTER files. Check this with the
DIR command. Execute the CP/M program with
)~IAIN
NOTE: Some CP/M machines may not be capable of
transmitting 8 bits per byte.
PAGE 3 - 44
To Next Page
Loading...