FILE MANAGER
SECTION 3.6
VER.V09F
The file is loaded not directly into a file, but to RAM
page O, the program execution page. When the file is
loaded and HUNTER displays
* Loading completed
File length=
88 Blocks
the data is written into a file with the SAVE command. In
this case.
>SAVE
88 MAIN.COM
The file MAIN.COM is now created.
Step
4 Load OVERLAY .OVR
The sequence of commands for loading this file is as
follows:
HUNTER
Host
HUNTER
>INP
PIP LST :=OVERLAY .HEX
>SAVE
40 OVERLAY.OVR
Step
5 Load PRODUCTS.TXT
This file is loaded with these commands:
HUNTER
Host
HUNTER
>INP
PIP U,T:=PRODUCTS.HEX
>SAVE
56 PRODUCTS.TXT
Step
6 Run the program
The three files MAIN.COM,
MA IN .OVR and PRODUCTS.TXT
should
all now be in HUNTER files. Check this with the
DIR command. Execute the CP/M program with
>MAIN
PAGE
3 - 46
To Next Page
Loading...