Husqvarna 536LiP4 - Assembling Shaft and Motor Cabling (536 Lipt5)

English – 37
Repair instructions
9.11 Assembling shaft and motor
cabling (536LiPT5)
1
Start with the cabling on the saw head side.
Thread the cabling through the inner shaft.
2
Thread the cabling into the sleeve holding the
cablinginplaceintheinnershaft.Fastenthe
sleeve in the shaft making sure it is positioned
correctly in the shaft.
3
Rotate the cabling 180° to fix it in the sleeve Lock
the cabling with a screw.
4
Push the telephone cabling inside the outer shaft.
5
Make sure the inner shaft guides are positioned
correctly in the outer shaft.
6
Push in the inner shaft so that the cabling
protrudes from the other end.
7
Assemble the clamp and its lock onto the outer
shaft. Tighten finger tight.