Husqvarna 536LiP4 - Dismantling the Control Unit

44 – English
Repair Instructions
9.17 Dismantling the control unit
1
Dismantle the battery housing as described in
"7 Basic dismantle/assembly" on page 20
2
Disconnect the connector to the motor.
Loosen the screws (G) to the control unit and the
screws (H) to the battery contact and lift out the
entire unit and the fan.
See figure 13b.
3
Unplug connector (D) for the keypad, main switch
and the fan.
SeeFigure14b.
Cleaning and inspection
Clean and inspect all parts of the control unit. The
control unit must always be replaced with a new
one if cracked or showing signs of other defects.
Always use original spare parts.
See figure 16b.
G
G
H
H
A
C
D
B
Fig13b
Fig14b