Husqvarna 536LiP4 - Assembling the Main Switch

English – 41
Repair Instructions
A
Fig13b
Fig14b
9.14 Assembling the main switch
1
Connect the contact (C) to the main switch. NB!
Make sure to apply grease to the contact sur-
faces and also the connector.
See figure 13b.
2
Connect cable (A) and place the main switch in the
battery housing.
SeeFigure14b.
3
Assemble the throttle trigger lock and throttle
trigger as described in "8.2 Assembling the throttle
trigger lock and throttle trigger" on page 25.
4
Assemble the control handle as described in
"7 Basic dismantle/assembly" on page 20
C