Husqvarna 536LiP4 - Dismantling the Main Switch

40 – English
Repair instructions
Fig12
Cleaning and inspection
Clean and check the main switch. The main switch
must always be replaced with a new one if cracked
or showing signs of other defects.
Always use original spare parts.
See figure 12
A
C
D
D
Fig10b
Fig11b
9.13 Dismantling the main switch
1
Dismantle the control handle as described in
"7 Basic dismantle/assembly" on page 20.
2
Dismantle the throttle trigger lock and throttle
trigger as described in "8.1 Dismantling the throttle
trigger lock and throttle trigger" on page 25.
3
Lift out the main switch and disconnect cable (A).
See figure 10b.
4
Take loose the contact (C) using a small screw-
driver to carefully free the catches (D) on each end
of the contact and main switch from each other.
NB! Do not pull the wires. Take special care to
avoid damaging the contact (D).
See figure 11b.