Husqvarna 540i XP - Safety Features and Battery Precautions; Chain Retention and Guards; Trigger Lockout Mechanism; Battery Safety Guidelines

5.3 Chain tensioner
5.3.1 To disassemble and assemble the chain
tensioner
1. Remove the drive sprocket cover. Refer to
To
remove and install the drive sprocket cover on page
9 .
2. Remove the 2 screws and the chain tensioner cover.
3. Remove the chain tensioner (A), shaft (B),
adjustment screw (C), washer (D) and O-ring (E)
from the drive sprocket cover.
A
B
C
D
E
4. Assemble in the opposite sequence.
5.4 Crankcase
5.4.1 To remove and install the air intake cover
1. Remove the screw.
2. Push the air intake cover rearward and carefully pull
out the air intake cover.
3. Install in the opposite sequence.
Note: Push the air intake cover against the
crankcase until you hear a click. Push the air intake
cover forward until the holes align.
CLICK!
1430 - 001 - 05.05.2020 Repair instructions - 11