7. Make sure that the edges of the power trigger and
the power trigger lockout are in the correct positions.
8. Assemble the crankcase. Refer to
To disassemble
and assemble the crankcase on page 12
.
5.6 Front handguard
5.6.1 To remove and install the front handguard
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
2. Remove the screw.
3. Carefully turn the front handguard to remove it from
the crankcase half.
4. Install in the opposite sequence.
5.7 Motor and control unit
5.7.1 To remove the motor, control unit and battery
connector
CAUTION: Do not pull the cables.
1. Remove the drive sprocket cover. Refer to
To
remove and install the drive sprocket cover on page
9
.
2. Remove the drive sprocket. Refer to
To remove and
install the drive sprocket on page 9
.
3. Remove the brake drum. Refer to
To remove and
install the brake drum on page 9
.
4. Remove the worm gear. Refer to
To remove and
install the worm gear on page 10
.
5. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
6. Disassemble the power trigger. Refer to
To
disassemble the power trigger on page 13
.
7. Remove the user interface. Refer to
To remove and
install the user interface on page 18
.
8. Make a note of how the cables and parts are
installed.
9. Remove the 2 screws on the battery connector.
10. Remove the 3 screws and the motor unit.
1430 - 001 - 05.05.2020 Repair instructions - 15
To Next Page
Loading...
