5.8 User interface
5.8.1 To remove and install the user interface
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
2. Disassemble the power trigger and the power trigger
lockout. Refer to
To disassemble the power trigger
on page 13
.
3. Disconnect the chain brake sensor.
4. Pull out the airflow cover and the user interface.
5. Disconnect the user interface.
6. Push out the clips and pull out the user interface
from the airflow cover.
7. Install in the opposite sequence.
5.9 Chain oil tank
5.9.1 To remove and install the chain oil tank
1. Empty the chain oil tank.
2. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
3. Remove the motor. Refer to
To remove the motor,
control unit and battery connector on page 15
.
4. Remove the screw and pull out the chain oil tank
from the crankcase.
5. Remove the grommet (A) and pull out the oil hose
(B) and the oil filter (C).
6. Install in the opposite sequence. Make sure that you
push the oil hose into the dedicated slot in the
crankcase when you install the chain oil tank.
CAUTION: Make sure that the grommet is
attached correctly to the chain oil tank.
CAUTION: Make sure that the oil filter is at
the bottom of the chain oil tank when you
install the chain oil tank.
18 - Repair instructions 1430 - 001 - 05.05.2020
To Next Page
Loading...
