4. Connect the user interface connector to the control
unit.
5. Connect the connector for the chain brake sensor
(A).
6. Put the motor (B), the control unit (C), the battery
connector (D) and the wire harness (E) into the
crankcase half.
7. Make sure that the connection points on the wire
harness are in the correct positions.
CAUTION: Make sure that the wire harness
and the cables do not touch the fan.
8. Hold the battery connector in position and install the
2 screws.
9. Hold the motor in position and install the 3 screws.
10. Install the user interface. Refer to
To remove and
install the user interface on page 18
.
11. Assemble the power trigger. Refer to
To assemble
the power trigger on page 14
.
12. Assemble the crankcase. Refer to
To disassemble
and assemble the crankcase on page 12
.
CAUTION: Make sure that all cables and
parts are installed correctly before you
assemble the crankcase.
13. Install the worm gear. Refer to
To remove and install
the worm gear on page 10
.
14. Install the brake drum. Refer to
To remove and
install the brake drum on page 9
.
15. Install the drive sprocket. Refer to
To remove and
install the drive sprocket on page 9
.
16. Install the drive sprocket cover. Refer to
To remove
and install the drive sprocket cover on page 9
.
1430 - 001 - 05.05.2020 Repair instructions - 17
To Next Page
Loading...
