4. Remove the 10 screws.
5. Remove the left crankcase half.
6. Assemble in the opposite sequence.
CAUTION: Make sure that all parts are
installed correctly in the crankcase to
prevent damage to the cables.
5.4.5 To replace the guide bar bolt
1. Remove the drive sprocket cover. Refer to
To
remove and install the drive sprocket cover on page
9
.
2. Remove the guide bar and the saw chain.
3. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
4. Remove the chassis. Refer to
To remove and install
the chassis on page 19
.
5. Remove the guide bar bolt.
6. Put the new guide bar bolt through the hole in the
chassis.
7. Use a hammer and a mandrel to install the new
guide bar bolt.
8. Install the chassis. Refer to
To remove and install
the chassis on page 19
.
9. Assemble the crankcase. Refer to
To disassemble
and assemble the crankcase on page 12
.
10. Install the guide bar and the saw chain.
11. Install the drive sprocket cover. Refer to
To remove
and install the drive sprocket cover on page 9
.
5.5 Power trigger
5.5.1 To disassemble the power trigger
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
12
.
2. Make a note of how the inner parts of the power
trigger handle are installed.
3. Remove the power trigger lockout.
4. Make sure that the power trigger lockout has no
defects. Replace the power trigger lockout if it has
defects.
1430 - 001 - 05.05.2020 Repair instructions - 13
To Next Page
Loading...
