English - 13
Min. 0.8 mm
Fig. 5
5.2 Cleaning and inspection
Clean and inspect all parts. The thickness of the brake
band must nowhere be less than 0,8 mm. See gure 5.
5.2.1 Cleaning and inspection of the air
channel
This chainsaw is equipped with an air channel that
reached from the ywheel side to the clutch side.
1. Do a visual check for dirt in the air channel.
2. Remove any dirt from the air channel by
pushing a Torx T27 or the like through the air
channel. Compressed air can also be used for this
purpose. See gure 6 and 7.
NOTE! Cleaning and inspection of the air
channel can only be performed if the
chain-guide plate and the cover over the chain
brake mechanism is removed (see gure 1) on
the clutch side and the starter on the ywheel
side (see chapter Starter).
CAUTION! If the air channel gets clogged
there is a risk that the chainsaw gets
overheated.
Chain brake
Fig. 6
Fig. 7
To Next Page
Loading...
