English - 49
18.3 Assembly
1. Clutch side: Place Guide shaft (clutch side, bottom)
in a vice and place the bearing on top of the
Guide shaft (clutch side, bottom) with sealing
upwards. Use Sleeve (clutch and ywheel side, top),
screw and nut to t the bearing on the clutch side of
the crankcase. See gure 9a and study the
illustration carefully.
2. Flywheel side: Place Guide shaft (ywheel side,
bottom) in a vice and place the bearing on top of the
Guide shaft (ywheel side, bottom) with sealing
upwards. Use Sleeve (clutch and ywheel side,
top), screw and nut to t the bearing on the ywheel
side of the crankcase. See gure 9b and study the
illustration carefully.
Fig. 9a
CAUTION! Exercise care so that dirt
and foreign particles do not get into the
bearing.
Crankcase and crankshaft
Note! The vice, screw and nut are not needed
when you use a press.
Fig. 9b
To Next Page
Loading...
