Husqvarna 572XP - Basic cutting technique

24 - English
11.3 Assembly
1. Fit the ywheel on the shaft. Turn it gently until the
key on the ywheel mates with the recess in the
shaft.
2. Fit the ywheel washer and nut. See gure 7.
3. Fit the two pawls on the ywheel. Make sure that
they can move freely when tted. See gure 5.
4. Remove the piston stop and reattach the spark plug.
See gure 5.
5. Fit the ignition module (B) without tightening the two
M5 screws. See gure 8.
6. Turn the ywheel so that its magnet (G) comes
opposite from the ignition module (B). See gure 8.
Fig. 7
Fig. 5
25Nm
7. Insert the feeler gauge Air Gap Tool (0.3 mm)
between the ignition module and the ywheel
magnet. The clearance only applies to the two lower
pegs on the ignition module. See gure 8.
8. Push the ignition module against the ywheel and
tighten the screws (D). See gure 8.
9. Fit the lead with cable and press the ignition cable
in place and attach the spark plug cap to the spark
plug.
10. Connect the cable connected to the contact on the
Autotune unit. See gure 6.
11. Fit the remaining parts on the chainsaw. See
respective chapters.
0,3mm
B
Air gap tool
G
D
Fig. 6
Fig. 8
Ignition system