Husqvarna 572XP - Changing a broken recoil spring; Air filter

34 - English
14.4 Dismantling the carburettor
1. Remove the cylinder cover and the air filter.
2. Disconnect the contact to the Autotune unit and the
stop wiring contact (G). See gure 8a.
3. XPG: Unscrew the contact clamp (two screws) (H)
and remove the thermostat (I). See gure 8b.
4. Remove the screws (E). Unhook the rubber
attachment (F) on both sides. See gure 9.
5. Loosen the pressure hose (A), return hose and
tankvent hose (B). See gure 8a.
E
F
F
F
E
Fig 9
Fig 8a
6. Remove the air filter holder. Let the air filter holder
remain in place in the cabling for the start/stop
switch.
7. Remove the fuel hose (C). See figure 8a.
8. Unhook the throttle cable (D). See figure 8a.
9. Press down the lug to release the carburettor. Lift out
the carburettor. See figure 10.
Fig 10
NOTE! Do not use any sharp tools to
loosen the hoses.
NOTE! The lug on the carburettor is securely
attached to the partition wall.
Fig 8b
H
I
D
C
G
Carburettor