Husqvarna 572XP - Cleaning and Inspection

48 - English
7. If the crankshaft bearing remains on the
crankshaft, remove it with the Puller tool. See
gure 6.
18.2 Cleaning and inspection
Clean all components and scrape of the remains
of gasket material from the mating surfaces of the
crankcase halves.
1. Check that the big-end bearing does not have any
radial play. Axial play is acceptable. Also make sure
that the big-end bearing does not have any score
marks or is discoloured on the sides. See gure 7.
2. Check that the bearing surfaces for the small-end do
not have any score marks or are discoloured. See
gure 8.
3. Check that the crankshaft main bearings do not have
any play or dissonance.
4. Check that the crankcase has no cracks.
Fig. 7
Fig. 6
CAUTION! If the bearings are mounted
in the crankcase, exercise care to avoid
dirt and foreign particles getting in.
Fig. 8
Crankcase and crankshaft