38 - English
14.8 Fitting the carburettor on the
chainsaw
1. Press the connector together and push it into place
in the holder. See figure 17.
2. Make sure the cabling is fitted to its mounting on the
intake flange. See figure 18.
3. Press the fuel hose (C) in place in the collar on the
intake bellows. See figure 19.
4. Hook on the throttle cable (D) in its mounting on the
intake bellows. See figure 19.
5. Make sure the lug on the carburettor hooks in place
on its mounting on the intake system. See figure 19.
Fig 19
Fig 17
Fig 18
CAUTION! Make sure that the fuel and
return hoses are not crushed.
Carburettor
NOTE! When replacing the carburettor, a rmware
download is required on the new unit and it has to
pass the test “autotest” in CST before use. See
instruction in CST. (Documents/Handheld/Auto-
Tune/User Guide).
To Next Page
Loading...
