15 ELECTRICAL SYSTEM 148
E00035-10
–
Mount and tighten screws
.
Guideline
Screw, headlight mask M5 5 Nm (3.7 lbf ft)
–
Mount the brake line and wiring harness in holder
.
Finishing work
– Check the headlight setting. ( p. 151)
15.9 Changing the headlight bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the headlight mask with the headlight. ( p. 145)
To Next Page
Loading...
Need help?
General
