21 TROUBLESHOOTING 176
Faults Possible cause Action
The engine does not turn when the
starter button is pressed
Operating error – Carry out the start procedure. ( p. 57)
The battery is discharged – Recharge the battery. ( p. 137)
– Check the quiescent current.
Fuse 1 or 2 blown – Change the fuses of individual power
consumers. ( p. 143)
– Set the clock. ( p. 47)
Main fuse burned out – Change the main fuse. ( p. 140)
No ground connection present – Check the ground connection.
Engine turns only if the clutch lever is
drawn
The vehicle is in gear – Shift gear to neutral.
The vehicle is in gear and the side
stand is folded out
– Shift gear to neutral.
The engine turns but does not start Operating error – Carry out the start procedure. ( p. 57)
Fuse 3 blown – Change the fuses of individual power
consumers. ( p. 143)
The plug-in connection of the fuel
hose connection is not connected
– Connect the plug-in connection of the fuel line.
Defect in fuel injection system – Read out the fault memory using the Husqvarna
Motorcycles diagnostics tool.
Throttle opened while starting – When starting, DO NOT open the throttle
– Carry out the start procedure. ( p. 57)
Engine has too little power Air filter is very dirty – Remove the air filter. ( p. 93)
– Install the air filter. ( p. 94)
Fuel screen is very dirty – Change fuel screen.
Fuel filter is very dirty – Check the fuel pressure.
To Next Page
Loading...
Need help?
General
