18. Remove the screws. Remove the cover.
19. Assemble the motor in the opposite sequence. Use
the correct torque. Refer to
Servicing data on page
13
.
7.9 Safety key switch
7.9.1 To remove the safety key switch
1. Remove the blade. Refer to
To remove and replace
the blade on page 22
.
2. Remove the motor from the chassis. Refer to
To
disassemble and assemble the motor on page 27
.
3. Put the motor cover on a cloth with the top down.
4. Remove the 4 cables from the safety switch.
5. Remove the screw and washer.
6. Remove the safety switch.
7.9.2 To install the safety key switch
1. Put a new safety switch in the correct position as
shown in the illustration.
2. Attach the washer and tighten the screw.
3. Attach the cables to the correct position.
4. Assemble the motor. Refer to
To disassemble and
assemble the motor on page 27
.
5. Attach the blade. Refer to
To remove and replace
the blade on page 22
.
32 - Repair instructions 361 - 001 -
To Next Page
Loading...
