Husqvarna LC 247Li - Control Panel

7.10 Control panel
7.10.1 To disassemble and assemble the control
panel on LC 347VLi and LC 247Li
1. Remove the 4 screws.
2. Disconnect the control panel cable from the circuit
board.
3. Assemble the control panel in the opposite
sequence. Use the correct torque. Refer to Servicing
data on page 13 .
7.10.2 To disassemble and assemble the control
panel on LC 247iX, LC 347iVX and LC 353iVX
1. Remove the 2 screws (A).
2. Remove the 3 screws (B).
3. Remove the lower part of the control panel (C). Lift
the top part of the control panel (D).
4. Disconnect the control panel cable (E) from the
circuit board (F).
D
E
C
E
F
A
B
B
5. Assemble the control panel in the opposite
sequence. Use the correct torque. Refer to Servicing
data on page 13 .
361 - 001 - Repair instructions - 33