4. Release the spring with a spring pull tool. Use a
hand to hold the product. Hold the product with one
hand. With your other hand, pull the tool quickly and
with force to release the spring.
5. Remove the shaft and snap ring to disengage the
height mechanism from the link arm.
6. Remove the link arm and tube as one unit. Remove
the wheel axle.
7. Assemble the rear axle in the opposite sequence.
Use the correct torque. Refer to
Servicing data on
page 13
.
7.8 Motor
7.8.1 To disassemble and assemble the motor
1. Remove the blade. Refer to
To remove and replace
the blade on page 22
.
2. Remove the transmission cable (only LC 347VLi, LC
347iVX and LC 353iVX).
3. Remove the 4 bolts.
361 - 001 - Repair instructions - 27
To Next Page
Loading...
