3.1.3 To set the product in operation position
1. Fold the handle to upright position.
2. Move the knobs up in the direction of the handle
until they stop and you hear a click.
3. Tighten the knobs fully.
3.1.4 To set the cutting height
The cutting height can be adjusted in 6 levels.
1. Move the cutting height lever down to decrease the
cutting height.
2. Move the cutting height lever up to increase the
cutting height.
CAUTION: Do not set the cutting height too low.
The blades can hit the ground if the surface of
the lawn is not level.
3.1.5 To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag.
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips.
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel.
361 - 001 - Prepare and do servicing on the product - 7
To Next Page
Loading...
