6.9.8 To remove air conductor
1. Refer to
To remove the power unit from the chassis
on page 23
,
To remove the cover from the power
unit on page 25
,
To remove the battery box on page
28
,
To remove the key switch on page 28
and
To
remove the fans and the air filters on page 29
.
2. Remove the 2 screws and remove the protection
plate from the air conductor.
3. If it is necessary, remove the air outlet and the air
filter on the air outlet.
4. Remove the 4 screws. Pull the motor cables out off
the hole in the air conductor and pull up the air
conductor.
6.9.9 To remove the motor
1. Refer to
To remove the power unit from the chassis
on page 23
,
To remove the cover from the power
unit on page 25
,
To remove the motor control box on
page 26
,
To remove the battery control box on page
27
,
To remove the battery box on page 28
,
To
remove the key switch on page 28
,
To remove the
fans and the air filters on page 29
and
To remove air
conductor on page 30
.
2. Remove the 4 bolts and pull up the motor.
3. Remove the 2 screws and the plate. Remove the
control panel cables. If it is necessary, replace the
cables and the rubber cable protection.
4. If it is necessary, replace the metal nets on the
baseplate.
30 - Repair instructions 1292 - 001 -
To Next Page
Loading...
