Husqvarna TE 300i US 2021 User Manual

12 SERVICE WORK ON THE CHASSIS
86
H03714-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 ( p. 157)
– On the slave cylinder, remove the protection cap and bleeder
screw
5
and mount bleeding syringe
4
.
H03715-10
– Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Mount and tighten screws
bleeder screw. Mount the protection cap.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.44 Removing the engine guard
H01655-01
–
Remove screws
1
and engine guard.
12.45 Installing the engine guard
H01655-01
– Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)

Husqvarna TE 300i US 2021 Specifications

General

Displacement	293.2 cc
Bore	72 mm
Stroke	72 mm
Transmission	6-speed
Seat Height	950 mm
Front Brake	260 mm disc
Starting System	Electric Start
Ground Clearance	370 mm
Engine Type	2-stroke single cylinder
Front Suspension	WP Xplor 48 mm fork
Rear Brake	220 mm disc
Frame	Chromium molybdenum steel
Wheelbase	1485 mm
Fuel System	Electronic Fuel Injection