What to do if there is too much fog/water build-up inside Hussmann Merchandiser?
If there's too much fog or water buildup inside your Hussmann Merchandiser, it could be due to the Miatech system's settings. Try decreasing the ON-time or increasing the OFF-time. Also, excessive water pressure could be the culprit, so try decreasing the water pressure.
How to fix little to no fog in my Hussmann Q3?
If you observe little to no fog in your Hussmann Merchandiser, there are several potential causes related to power supply. First, ensure that the power switch on the Miatech unit and the "Fogger System" switch on the case are both turned to the "ON" position, verifying that the light is illuminated. Also, check the GFCI on the power outlet and reset it via the "RESET" button if it has tripped, ensuring the green LED is lit. Confirm that the case has power and that the fogger time clock is not on the nighttime OFF cycle. Other possible causes include the case being in a defrost cycle (wait until it completes), the fogging system being on its "Off" time (adjust the timer), ice on the discharge air grill (check air temperatures and defrost heater operation), pinched air/water lines (ensure li...
Warning against overloading the case or standing on top to prevent glass breakage.
Overview of fogging system setup and differences between primary/secondary cases.
Steps for physically mounting the fogger system and installing the nozzles.
Procedures for routing water, air, and heater wires for the fogging system.
Configuration settings for the fogger system controller and RO filter requirements.
Connecting the heater relay and operating the fogger system switch.
Setting up and programming the system clock for fogger operation timing.
General| Brand | Hussmann |
|---|---|
| Model | Q3 |
| Category | Merchandiser |
| Language | English |
To Next Page