Hyd-Mech M-16 - Page 35

Pg 2.21
ADDITIONADDITION
ADDITIONADDITION
ADDITION
AL CUTTING SETUP EXAMPLESAL CUTTING SETUP EXAMPLES
AL CUTTING SETUP EXAMPLESAL CUTTING SETUP EXAMPLES
AL CUTTING SETUP EXAMPLES
, ,
, ,
,
CONTINUEDCONTINUED
CONTINUEDCONTINUED
CONTINUED
EXAMPLE # 3
Material Bundle -Low carbon steel 2" x 2" Tube with 1/4" wall, 12 piece bundle
(50mm x 50mm with 6mm wall)
Dimensions - 6" x 8" (150mm x 200mm)
STEP ISTEP I
STEP ISTEP I
STEP I
Effective Material Width: 5" ( .6 X 8" ) 120mm (.6 x 200)
STEP 2STEP 2
STEP 2STEP 2
STEP 2
Feed Force limit setting for 8" Diameter material Refer to Feed Force Limit
Setting in Step 2
STEP 3STEP 3
STEP 3STEP 3
STEP 3
Optimum blade pitch (TPI): 3/4 T. P. I.
STEP 4STEP 4
STEP 4STEP 4
STEP 4
Optimum blade speed for 5 " effective 320 ft/min (100m/min)
material width
STEP 5STEP 5
STEP 5STEP 5
STEP 5
Feed Rate for 3/4 TPI blade: 4.0 in/min (100mm/min)