Pg. 2.5
MITSUBISHI BASED PLC CONTROL SYSTEM
NOTE: This instruction manual is applicable to the M16A, M20A, H18A to H32A
machines equipped with a Mitsubishi PLC, c/w feed rate display, manufactured after and
including the following serial numbers:
Machine Model Serial #
M-16A S0298036
M-20A T0198019
H-16A B0398162H
H-20A C0398114H
H-26A D0598036H
H-32A
OPERATION OVERVIEW
The PLC is a programmable length controller which allows the operator to run the machine in
both manual and automatic modes.
In manual mode, all functions can be operated by using a combination of selector switches on the
control console and the PLC function buttons. Also the operator has the ability to execute a single cut
utilizing a preprogrammed "Single Part Cycle".
In automatic mode, the PLC has the capacity to program and store 99 jobs. Designated job
numbers can be programmed for quantity required (maximum of 999 pieces) and lengths from 0" to
220" (5588mm).
Jobs can be run individually or in a QUEUE which allows a maximum of 5 jobs to run consecu-
tively.
NOTE: If an emergency situation arises during any operations, use the large red
mushroom "emergency stop" button located on the control panel to shut down the
machine.
To Next Page