Pg. 2.4
GUIDE ARM - GUIDE ARM -
GUIDE ARM - GUIDE ARM -
GUIDE ARM - This switch controls the position of the idler (left) guide
arm.
OPTIONAL CONTROLS
CENTER ROW
BLADE SPEED - BLADE SPEED -
BLADE SPEED - BLADE SPEED -
BLADE SPEED - This option is the REMOTE BLADE SPEED. This dial will
increase or decrease the speed at any time while the blade is running.
WORK LAMP - WORK LAMP -
WORK LAMP - WORK LAMP -
WORK LAMP - This option switch has two positions, OFF and ON.
FAST APPROACH - FAST APPROACH -
FAST APPROACH - FAST APPROACH -
FAST APPROACH - (On Machines equipped with Electric Fast Approach)
By depressing this button, the head will descend at an accelerated rate
when the head is receiving a signal from either the head selector switch
in manual mode or the PLC in automatic mode.
OPERATOR PANEL SWITCHES
BOTTOM ROW
(continued)
LASER GUIDE - LASER GUIDE -
LASER GUIDE - LASER GUIDE -
LASER GUIDE - This option switch has two positions, OFF and ON.
BOTTOM ROW
HEAD SWING 30 - HEAD SWING 30 -
HEAD SWING 30 -
HEAD SWING 30 -
HEAD SWING 30 - This is a two position push button. By pressing the
button in partially, the head will SLOWLY swing towards the 30 degree
position until it reaches 30 degrees or the button is released. This allows
for a fine adjustment in the cut angle. If pressed fully in, the head will
swing at a FAST rate.
NOTE: The HEAD CONTROL switch must be in the "HOLD" position for
this button to operate.
To Next Page