Pg. 2.3
COOLCOOL
COOLCOOL
COOL
ANT - ANT -
ANT - ANT -
ANT - This switch has three positions, WASH, OFF, and ON. In the
WASH position, the coolant system will operate when there is power to the
machine, this allows using the wash gun to clean the machine. In the OFF
position, the coolant system is inactive. In the ON position the coolant system
will only run when the head is descending. This minimizes coolant carry over
on the stock.
STST
STST
ST
OP -OP -
OP -OP -
OP - This mushroom button stops the blade and hydraulic motors. Both
vises will hold their position but, pressure will begin to fall off. Long pieces of
work should always be supported so they will not become loose over time and
fall while the machine is shut down.
HEAD SWING 90 - HEAD SWING 90 -
HEAD SWING 90 - HEAD SWING 90 -
HEAD SWING 90 - This is a two position push button. By pressing the button
in partially, the head will SLOWLY swing towards the 90 degree position until
it reaches 90 degrees or the button is released. This allows for a fine
adjustment in the cut angle. If pressed fully in, the head will swing at a FAST
rate.
NOTE: The HEAD CONTROL switch must be in the "HOLD" position for this
button to operate.
OPERATOR PANEL SWITCHES
CENTER ROW
BOTTOM ROW
BLBL
BLBL
BL
ADE STADE ST
ADE STADE ST
ADE ST
OP BOP B
OP BOP B
OP B
UTTUTT
UTTUTT
UTT
ON - ON -
ON - ON -
ON - Stops the blade. If the blade is stopped during a
cycle, the cycle will continue but will not let the head descend until the blade
is started.
SHUTTLE VISE - SHUTTLE VISE -
SHUTTLE VISE - SHUTTLE VISE -
SHUTTLE VISE - This switch has three positions, CLOSE, OPEN, and
HOLD. In CLOSE, the vise will close all the way, or until it encounters
enough resistance to stop it. With the switch held in the OPEN position
the vise will open all the way or until the switch is released. With the
switch in the HOLD position, the vise will stay where it is and will not move
freely although it will not resist a large force indefinitely without creeping.
To Next Page