Pg. 2.2
HYDRAULIC START - HYDRAULIC START -
HYDRAULIC START - HYDRAULIC START -
HYDRAULIC START - To start the hydraulic system, the switches for the
head and both vises must be in the "
NEUTRAL" NEUTRAL"
NEUTRAL" NEUTRAL"
NEUTRAL" position. The
"HYDRAULIC START" button must be depressed and held in
momentarily until the PLC display becomes active.
OPERATOR PANEL SWITCHES
TOP ROW
FRONT VISE - FRONT VISE -
FRONT VISE - FRONT VISE -
FRONT VISE - This switch has three positions, CLOSE, OPEN, and HOLD.
In CLOSE, the vise will close all the way, or until it encounters enough
resistance to stop it. With the switch held in the OPEN position the vise
will open all the way or until the switch is released. With the switch in the
HOLD position, the vise will stay where it is and will not move freely
although it will not resist a large force indefinitely without creeping.
HEAD CONTROL -HEAD CONTROL -
HEAD CONTROL -HEAD CONTROL -
HEAD CONTROL - This switch has three positions: UP, HOLD and DOWN.
The switch is inactive unless the PLC is in manual mode. In the UP
position, the head will rise until it trips the head up limit which is
adjustable via the PLC. In the HOLD position the head will stay still. In the
DOWN position the head will descend until it reaches the bottom of the
stroke. The speed of descent is controlled by the Head Feed and Head
Force Limit controls.
CYCY
CYCY
CY
CLE STCLE ST
CLE STCLE ST
CLE ST
ARAR
ARAR
AR
T / PT / P
T / PT / P
T / P
AA
AA
A
USE - USE -
USE - USE -
USE - This button starts the cutting cycles and will stay
illuminated white until the cycles are completed. The PLC control system
will prompt you to start the blade if it is not running. The machine will then
begin the automatic cycle until completed when it will shut itself off. The
current cycle can be PAUSED by pressing this button at any time during a
cycle and restarted by pressing it again.
BLBL
BLBL
BL
ADE STADE ST
ADE STADE ST
ADE ST
ARAR
ARAR
AR
T -T -
T -T -
T - The blade can be started only when the hydraulics are
running in either manual or auto mode.
NOTE: In automatic Mode the head will not descend until the blade has
been started, which the PLC will prompt the operator to do so.
To Next Page