Hyd-Mech M-16 - Lubrication

Pg 3. 4
LL
LL
L
UBRICAUBRICA
UBRICAUBRICA
UBRICA
TIONTION
TIONTION
TION
The design of the M-16, M-20 was intended to minimize maintenance, although periodically
certain moving parts need lubrication. We recommend that this periodic lubrication be done once a
month using any general purpose grease at the points indicated with a circle.
Adjustable guide arms bar.
Idler wheel tensioner.
Bundling guides.
Horizontal pivot pivot.
Vise shafts.
4 Points (under plugs)
(2 points on P models)
Lubricated every two months.
Shuttle bearing housing.
(not present on P models)
1 Point on each bearing
housing Lubricated every
two months.