Hyd-Mech M-16 - Head Height Calibration

Pg 3. 20
HEAD HEIGHT CALIBRAHEAD HEIGHT CALIBRA
HEAD HEIGHT CALIBRAHEAD HEIGHT CALIBRA
HEAD HEIGHT CALIBRA
TIONTION
TIONTION
TION
1) Enter the PLC parameter screen as per Length Calibration Procedure on Pg. 3.19.
2) Using the arrow cursor keys scroll down until the screen displays :
HT CLB "ENTER" 0
ACT HT 00.000
3) With the cursor on the 0 , press the ENTER key. The cycle start button will begin to
flash, the head will move to it's down limit and then will move up to it's full upper limit.
4) Measure the distance from the vise horizontal wear strip to the blade teeth tips, and enter
this value in the ACT HT parameter. Measurement must be made along the front vise
datum jaw.