Hydac CS1000 series User Manual

Setting limit values
Mode M3
Switching output – OPEN
LED of SP1 – off
Switching output –
CONDUCTIVE
LED of SP1 – on
5 consecutive measured values ≤
limit value ( ) or
measurement stopped
Measurement is currently in
progress and one or more of the
last 5 measured values > limit
value ( )
Mode M4
Switching output – OPEN
LED of SP1 – off
Switching output –
CONDUCTIVE
LED of SP1 – on
Start or result of
check
measurement after
test cycle time: a
value ≥
reactivation
threshold
( )
For 5 consecutive measurements:
all measured values ≤ lower limit
value ( )
or measurement stopped
Measurement is in progress and
during one or more of the last 5
measurements: one measured
value > lower limit ( )
or all measurements ≥
reactivation threshold
( )
Upon the test cycle
time elapsing for
the duration of a
check
measurement
Is open again when all measured
values < reactivation threshold (
) Restart test cycle
time
Test cycle time has elapsed
Mode Single
Switching output – OPEN
LED of SP1 – off
Switching output –
CONDUCTIVE
LED of SP1 – on
-
Device ready function
Always CONDUCTIVE except in
the event of an error
ContaminationSensor CS1000
en(us)
Page 65 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25

Hydac CS1000 series Specifications

General

Brand	Hydac
Model	CS1000 series
Category	Accessories
Language	English