Hydac CS1000 series - Storing the sensor; Decoding the type label

Storing the sensor
Storing the sensor
Store the sensor in a clean, dry place, in the original packing, if possible. Do
not remove the packing until you are ready to install the unit.
Rinse the sensor completely with Cleanoil before putting it into storage.
Use and dispose of used cleaning agents and flushing oils properly and in an
environmentally friendly way.
The conditions required for storage are in the "Technical Data" chapter on
page 118.
Decoding the type label
For identification details of the ContaminationSensor, see the model code
label. This is located on the back of the unit and contains the exact product
description and the serial number.
Row
->
Description
Model
->
Model code; for details, see page 123
P/N
->
Part no.
S/N
->
Serial-no.
Date
->
Year/week of production and hardware index
Max. INLET press.:
->
Maximum operating pressure
ContaminationSensor CS1000
en(us)
Page 16 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25