Safety Information
The product was built according to the statutory provisions valid at the time of
delivery and satisfies current safety requirements.
Any residual hazards are indicated by safety information and instructions and
are described in the operating instructions.
Observe all safety and warning instructions attached to the product. They
must always be complete and legible.
Do not operate the product unless all the safety devices are present.
Secure the hazardous areas which may arise between the product and other
equipment.
Maintain the product inspection intervals prescribed by law.
Document the results in an inspection certificate and keep it until the next
inspection.
Hazard symbols
These symbols are listed for all safety information in these operating
instructions which indicate particular hazards to persons, property or the
environment.
Observe these instructions and act with particular caution in such cases.
Pass all safety information and instructions on to other users.
General hazard
Danger due to electrical voltage / current
Danger due to operating pressure
ContaminationSensor CS1000
en(us)
Page 10 / 136
BeWa CS1000 3764916d 300 en-us 2017-09-25.docx 2017-09-25
To Next Page
Loading...
Need help?
General
