Need help?Do you have a question about the Hydrajaws 2000 and is the answer not in the manual?
General| Test Medium | Hydraulic Oil |
|---|---|
| Type | Hydraulic test equipment |
| Maximum Pressure | 2000 bar |
| Hydraulic Pressure | 63 MPa |
| Accuracy Full Scale | ± 1% |
| Operating Temperature | 0 - 50 °C |
Steps for correctly setting up the Hydrajaws tester for a test, including adaptor and leg adjustments.
Detailed steps for conducting the actual test, loading the fastener, and releasing the load.
Instructions for using the bolt test adaptor directly, with slotted, and threaded button adaptors.
Instructions for fitting M10, M12, M16, and M20 threaded stud adaptors for anchors.
Procedure for removing insulation and fitting the insulation adaptor for testing.
Guidance on using M5, M6, M8, and M10 threaded rod adaptors, especially for wall ties.
Instructions for using the Clevis adaptor to test ringbolts.
Procedure for testing M16 drop-in scaffold tie anchors using the kit.
Steps for testing eye type anchors, including adaptor replacement and rig setup.
Procedure for testing safety harness eyebolts, including bridge placement and load application.
Steps for testing ladder restraint hooks, focusing on load application and failure observation.
Overview of site testing wall ties for suitability and installation quality.
General procedure for applying load to wall ties, connecting adaptors and bridge.
Steps for testing wall ties installed in the inner leaf of a wall.
Notes on testing outer leaf mechanical connections of wall ties.
Procedure for preparing samples and conducting pull-off tests for material bond strength.
Instructions for lubricating the rod of the tester, including handle removal.
Information on checking the oil level and when refilling is necessary.
To Next Page
